¶ About the module
This module will allow you to disable the commands that you don't want to use. This module itself allows you to disable any Filo command.
¶ Module exceptions
This module has some exceptions, which are mentioned below:
- If the command you are trying to disable is in a protected category:
- Core.
- Developer.
¶ Steps to configure the module
ALERT
You need theADMINISTRATORpermission to execute this action.
INFORMATION
You should replace f! with the current prefix you have set.
More information on how to change the prefix here.
WARNING
Filo must have theVIEW_CHANNEL,SEND_MESSAGES,EMBED_LINKSandUSE_EXTERNAL_EMOJISpermissions, otherwise the module will not work correctly.
¶ Step 1: Activate the module
To activate the module you must run the command: f!config enable disable-commands.
¶ Step 2: Enable or disable a command
INFORMATION
If you disable a command, no one will be able to run it again until you enable it again.
To enable or disable a command you must execute the command: f!config commands <enable/disable> <Command> (Do not include <> when executing the command).
Example: f!config commands disable ping.